SATO E Series Manuel de l'opérateur télécharger pdf (Page 44)

3. Press the FEED key to feed out a blank label.

4. Adjust the position using the OFFSET potentiometer on the front control panel

and feed another label by depressing the FEED key. Repeat this procedure until

the label is fully released from the liner.

DISPLAY

This potentiometer is used to adjust the contrast of the LCD display for optimum

viewing under various lighting conditions.

The PRINT potentiometer is used to adjust the amount of heat (i.e., power) applied to

the head for printing. It provides a continuous range of adjustment. Maximum print

darkness is obtained by turning the potentiometer all the way clockwise and a

maximum counterclockwise setting will give the lightest print.

NOTE: The PRINT potentiometer adjustment will affect the darkness in all of the

command code speed and darkness ranges.

Page 3-8 PN 9001074 Rev. B SATO CL Series “e” Printers

Section 3. Configuration

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 101 102

Pas de commentaire

SATO E Series Manuel de l'opérateur Page 44