SATO GL 4xxe Series Guide d'installation télécharger pdf (Page 10)

10

ｺ

ﾈ

ｸ

ﾀ

ｰ

1) Mounting the printer above the rewinder

A total of seven screws (cross recessed

hexagonal bolt M4x10) are used to install the

internal rewinder-dispenser to the printer

chassis

(Do not damage the PCB when using any tool

such as screwdriver)

Do not tighten all seven screws until you are

sure the installation alignment is correct. Also

check that all connectors have been

reconnected.

Two screws removed originally from the front

of the printer, will be left unused.

Next, we will reinstall the front cover of the

internal rewinder-dispenser.

First, connect the internal rewinder’s cable to

the connector at the front of the printer, as

shown here.

Make sure it is not compressed in any way

when the front cover of the internal rewinder

is mounted next.

Reinstall the front cover of the internal

rewinder and and temporarily tighten the two

screws (bind screw M4×4) used to secure

each side of the front cover.

Figure 2d. Printer mounted on top of

the internal rewinder

Connector

Figure 2e. Connecting the internal

rewinder signal cable

Figure 2f. Mounting the front cover

Four screws to be

secured in total

1 2 ... 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire