SATO GL 4xxe Series Guide d'installation télécharger pdf (Page 6)

6

Removing the front cover

Tool(s) required

Flat blade screwdriver

(recommended)

1. Loosen and remove the

thumbscrew fastener that

secures the front cover.

2. Pull the outer edge of the

front cover outwards, and

then push the entire cover in

the direction shown by the

arrow. The cover will be

dislodged.

3. Put the cover and

thumbscrew aside.

Note:

Do not use force when removing

the front cover as this can

potentially damage the plastic

holding pins on the cover.

Removing the LEFT Side Cover

Tool(s) required

#1 Phillips + screwdriver

1. Remove three screws (see

red circles in the picture) that

secure the cover.

2. Slide the cover towards the

rear of the printer for about an

inch, and then lift the cover up

to remove it from unit (refer to

the red arrows in the picture).

3. Place the cover and three

screws aside for now.

Figure 1a.

Removing the thumbscrew

Figure 1b.

Pulling out the front cove

r

Figure 1c.

The LEFT side cove

r

Figure 1d.

Side cover removed

1

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire