SATO GL 4xxe Series Guide de l'utilisateur télécharger pdf (Page 23)

【Example 5】

Description:

This example illustrates to write EAN 128 data to the tag.

Data:

＜A＞

＜V＞50＜H＞50＜X22＞,3114F536CCCE4C3097000000

＜IP0＞e:a,d:34017587461099671,f:0,s:10,c:7;

＜Q1＞

＜Z＞

Note:

The EAN 128 data will be encrypted as per EPC Generation 1 Tag Data Standards Version 1.1

Rev.1.27 (SSCC 96).

【Example 6】

Description:

This example illustrates to write EAN 13 data to the tag.

Data:

＜A＞

＜V＞50＜H＞50＜X22＞,301803CB4F48B38000000001

＜IP0＞e:c,d:4003885006606,f:0,t:7,c:6,n:000000000001;

＜Q1＞

＜Z＞

Note:

The EAN 128 data is encrypted as per EPC Generation 1 Tag Data Standards Version 1.1

Rev.1.27 (SGTIN 96).

[Notes]

1． If EPC code cannot be coded into the tag, printer will execute an error action according to the settings

done from RFID mode.

2． Except “e”, which is imperative and in the fixed position (top), parameters can be omitted when not

needed.

3． Multiple print designations are only possible if IP0 command is used in combination with other print

data.

4． A word about access code, two parameters are used for access code (p: present access code and a:

New access code to be encoded into the tag)

- If ‘a’ parameter is used alone in an IP0 command, the data of ‘a’ parameter will be written in to

the access code area of the tag.

- If ‘p’ parameter is used alone in an IP0 command, the data of ‘p’ parameter will be used as a key

to write other memory blanks of the tag. The access code area remains unchanged.

- If both ‘a’ and ‘p’ parameters are used in an IP0 command, the data of ‘p’ parameter will be used

as a key to write other memory blanks of the tag and data of ‘a’ parameter will be written in to

the access code area of the tag.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Pas de commentaire

SATO GL 4xxe Series Guide de l'utilisateur Page 23