SATO GL4XXE Guide d'installation télécharger pdf (Page 6)

Simple-Dispenser Installation Guide

GL4xxe Simple-Dispenser Installation

4. Affix the dispenser (3) to the printer by plugging the white connector (4) into

the complementary connector (4) on the printer.

5. Mount the simple dispenser by hooking it as shown in the illustration at the

bottom of the page. Affix the dispenser with three supplied screws.

6. Mount the replacement front cover (5) onto the front of the printer, using the

thumbscrew removed in Step 3 to screw it back into place. Note: Ensure that

the cable is not pinched when you install the label cutter cover in place.

7. Restore power to the Printer and configure the printer to use the dispenser

(see next page).

Figure 2. Installing the dispenser and replacement front cover

1 2 3 4 5 6 7 8

Pas de commentaire

SATO GL4XXE Guide d'installation Page 6