SATO LP 100R L Guide d'installation télécharger pdf (Page 18)

INSTALLATION GUIDE

2.2 Removal of Packing Material and Accessories Boxes

1. Remove the two accessories boxes from the stacker tray.

2. Raise the stacker table upward.

3. Insert the ramp into the pallet on the front of the printer as shown in Figure 2-3.

Make sure that the ramp cannot separate from the pallet.

Figure 2-3

4. Adjust the printers leveling feet (4) upward from the base plate. Allow a minimum of 20mm of

clearance for the printer to move unobstructed down the ramp. (See Figure 2-4)

Figure 2-4

Ramp

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 79 80

Pas de commentaire

SATO LP 100R L Guide d'installation Page 18