SATO LP 100R L Guide d'installation télécharger pdf (Page 68)

A P P E N D I X E

E-2

BURSTER UNIT INSTALLATION, CONTINUED

4. Remove the exit guide A by removing the four

screws. (Figure E-3)

Figure E-3

5. Remove the exit guide B by removing the two screws.

(Figure E-4)

Note: The exit guide A and B are no longer

necessary together with the screws when

the burster unit is installed. Store it, if

necessary.

Figure E-4

6. Install the paper guide on to the burster unit.

7. Install the harness on to PWB-F to the PJ-7

connector. Install the harness in the cable clamp.

(Figure E-5)

8. Install the burster unit with 2 screws and 2

connectors.

9. Connect the harness to the burster.

10. Connect the burster home sensor harness, located

in the harness.

11. Install all covers in their original positions.

12. Stick the Burster Jam Removal Instruction Label to

the inside of the left cover.

13. Close the left door.

Figure E-5

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Pas de commentaire

SATO LP 100R L Guide d'installation Page 68