Sato CT410 Manuel d'utilisateur télécharger pdf (Page 37)

FACTORY/SERVICE TEST PRINT

The Factory/Service Test Label prints the internal operating parameters of the printer.

1. Open the print head by pushing the Head Latch Lever to the rear.

2. Press the LINE and FEED keys while simultaneously turning the POWER switch

to the ON position.

3. When the printer beeps, release the LINE and FEED keys. The printer will then

beep 3 times indicationg it is in the Factory/Service Print Test mode.

4. Latch the Print Head in the down position.

5. Press the LINE key to print a large (4" wide") Factory/Service Test Label.

Press the FEED key to print a small (2" wide) Factory/Service Test Label.

6. The printer will begin printing a series of test labels, the first containing the

operational parameters of the printer followed by one containing the internal

printer settings. these two label formats will alternate until the FEED key is

pressed, suspending the print operation. If the FEED key is pressagain, the

printing will resume.

7. To remove the printer from the Factory/Service Print Test mode, remove power by

placing the POWER switch in the OFF position.

Section 2. Installation and Configuration

SATOCT SeriesPrinters9001069A Page2-21

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 198 199

Pas de commentaire

Sato CT410 Manuel d'utilisateur Page 37